Miatapower List Archive

This read-only message was archived from a public mail list.
Mail From: Greer <(email redacted)>

I tried this on miataforum with no luck, so I thought I would check here.

I have a tec-2 installed on my 91 miata. At one time I had a link piggyback
installed on the car that did boost control. I still have the solenoid
plumbed into the vac lines, but not hooked up to anything electrically. My
question is, will this solenoid/valve work with the tec-2. I know a
restrictor is normally used, is it needed here? where should I source it from.
I am leery of powering the unit and causing damage to the solenoid, etc so
I thought I would check here.

Thanks,
Greer